Grille Logo Installation Guide – SEAT Ibiza 6L / Leon MK1
Compatible with SEAT Ibiza 6L and SEAT León MK1
Install your new logo in a few minutes without complications by following these steps.
⏱️ Estimated time
👉 Less than 5 minutes
🛠️ Difficulty
👉 Easy
1️⃣ Remove the original logo
Locate the original logo on the grille and remove it carefully.
- You can do it by hand or with a flat tool
- Pry gently if necessary
- Avoid excessive force to prevent damage to the grille
2️⃣ Cut the original logo fasteners
Once the logo is removed:
- Identify the tabs or rear fasteners
- Cut them to completely clear the space
- Make sure the area is clean
3️⃣ Install the new logo
Place the new logo from the front of the grille.
- Align the piece correctly
- Press inward
- You should hear a “click” as it snaps into place
✅ Final check
- Verify that the logo is securely fastened
- Make sure it is straight
- Check that it does not move
⚡ Result
✔ Quick installation
✔ No complex tools
✔ Immediate visual change
💡 Recommendations
- Do not force the part if it is not aligned
- Install carefully to avoid marks
- If in doubt, review the steps before proceeding
🔥 Important note
👉 This installation is valid for:
- SEAT Ibiza 6L/FR
- SEAT León MK1/Cupra/FR
Compatible with:
- Original grilles
- OrbiWorks grilles
🛠️ Support
If you have any problems during installation or any questions:
👉 You can contact us at:
soporte@orbiworks.es
We will help you as soon as possible so you can install your logo without complications.
🚀 Conclusion
👉 In less than 5 minutes you can completely change the front of your car.
